Basic Function 1. Mechanical step register 5+1(default) , 6 digit no decimal OR LCD display 6+1, 5+2; 2. Bi-directional total active energy measurement ,reverse active energy measure in the total active energy; 3. Three phase power supply , the meter also measure when loss one phase (any one wire in three phase three wire ) or when loss two phase (any two in three phase four wire; 4. Loss phase LED indicates working of phase; 5. Pulse LED indicates working of meter, Pulse output with optical ...

General 1. Overload protection 2. Short circuit protection 3. Controlling 4. Used in residential building, non-residential building, energy source industry and infrastructure. 5. According to the type of instantaneous release classified as follows : type B(3-5)ln, type C(5-10)ln, type D(10-20)ln Release Curve Specifications Overall and Mounting Dimensions(mm)

Operating conditions Altitude ≤2000m. Ambient temperature Range: -5℃ ~ +40℃, with daily average ≤ +35℃. Atmospheric condition: when the highest temperature is +40℃, the relative humidity of air shall be no more than 50%, higher relative humidity shall be allowable at lower temperature, for instance air humidity may reach 90% at +20 ℃. As for dews, which contigently appear due to change of temperature, special steps should be taken. Pollution Level: Level 3. Inclination between installation p...

Working Conditions 1. Power capacitor should confirm left voltage reduce to rated voltage 10% to input again after the power was cut off, normally it will need 200s almost. so it would choose the power controller which has input and reput lock time function after cut off the power. If choose normally power controller, it must install speediness discharge power equipment. it would not limited which use adopting same electric factor input and chip switch. 2. Altitude level is not more than 200...

General 1. Overload protection 2. Short circuit protection 3. Controlling 4. Used in residential building, non-residential building, energy source industry and infrastructure. 5. According to the type of instantaneous release classified as follows: type B(3-5)ln, type C(5-10)ln Release Curve Specifications Overall and Mounting Dimensions (mm)