Home >  Products > Low-voltage Electrical Products > MCCB > YCM1 Moulded Case Circuit Breaker

YCM1 Moulded Case Circuit Breaker


  • General

    YCM1 series moulded case circuit breaker(herein after called circuit breaker)is one of our new type circuit breakers, which adopts international advanced design and manufactural technology, it can be divided into L-type (standard type), M-type (higher breaking type), H-type (current limiting type) according to the rated ultimate short circuit breaking capacity (Icu). With the features of small and compact, high breaking capacity, short arcing-over distance, anti-vibration, the circuit breaker is used popularly on land and marine products, they are applied for the power distribution network of AC 50Hz,rated insulation voltage 800V (YCM1-63 to 500V), rated working voltage 690V(YCM1-63 to 400V) and below, rated current up to 1600A, it can be used to distribute electric power and protect power equipment against overload, short circuit, undervoltage etc, It also takes protective effect when motors unfrequently start and protecting against overload, short circuit and lacking voltage. In the series, frame ranging from 63-630A three-pole product also comes with a transparent cover, it is convenient for customer to observe the product operation.
    The circuit breaker can be installed vertically, or horizontally. This product complies with standard of IEC60947-2, GB14048.2, specification of 6A only has electromagnetic (instantaneous) type; with () is not recommended 225L type with cage terminal can be elevated.


    Type designation


    Note:
    1.blank for power distribution,2 for motor protection
    2.blank for direct operation with handle, Z for operation with rotary handle, P for motor-driven operation.
    3.There are 4 types of N-pole for 4P breaker:
    A:Without current release components, N-Pole is always at making status(not breakers);
    B:Without current release components, N-Pole makes with the other three poles;
    C:With current release components, N-Pole makes with the other three poles;
    D:With current release components, N-Pole is always at making status(not breakers);


    Function and features

    1.Temperature: -5℃~+40℃; the average value within 24h shall not exceed +35℃. For the circuit breaker with thermo-magnetic release, +40℃ is set to be the standard temperature for ratings. For temperature not between -5℃~+40℃, please contact us for temperature compensation correction; Altitude: not exceed 2000m (Please contact with us for reduction coefficient if altitude at the mounted site exceed 2000m)
    2.Pollution grade: Grade 3;
    3.Air conditions:
    4.At mounting site, relative humidity not exceed 50% at the max temperature of +40℃, higher relative humidity is allowable under lower temperature. For example, RH could be 90% at +20℃, special measures should be taken to occurrence of dews.
  • Specifications


    Release methond and accessories code


    Figure and dimension of normal type electric operation device




    Figure and dimension of normal type electric operation device








  • Overall and mounting dimensions(mm)
    1.Curves






    Figure and-installation dimension of rear plug-in wiring type


    Overall and mounting dimensions(mm)


    Motor-driven operation accessories













    Rotary manual operation mechanism accessories