Home >  Products > Low-voltage Electrical Products > AC Contactor > CC1-D AC Contactor

CC1-D AC Contactor


  • General

    CC1-D series AC Contactor is suitable for using in the circuits the rated voltage up to 690V AC 50Hz or 60Hz. Rated current up to 95A with AC-3 type.
    CC1-D-N series reversible AC Contactor is suitable for using in the circuits the rated voltage up to 690V , rated current up to 95A, frequency is 50Hz or 60Hz and used in motor reversible controlling. Mechanical interlock of it can ensure the reliability for two reversible contacts' shift.
    Standard: IEC60947-4-1,GB14048.4

    Type designation


    Operation and installation condition

    1.Ambient air temperature:-5℃~+40℃, average temperature of 24 hours must below +35℃
    2.Altitude:≤2000m
    3.Relative humidity: The maximum temperature of 40 degrees,the air relative humidity not exceed 50%, at a lower temperature can allow for a higher relative humidity, for instance, if the temperature is 20℃, the air relative humidity could up to 90%, if humidity changes as a result of occasional gel generated,should eliminate it.
    4.Pollution level: 3
    5.Installation category: III
    6.Installation position: The installation degree of the tilt and vertical plane should not exceed ±5℃。
    7.Shock vibration: Products should be installed and used without significant shake, shock and vibration place.

  • Specifications

    1. CC1-D contactor's specifications and technical characteristic. Table1

    TypeCC1-D09CC1-D12CC1-D18CC1-D25CC1-D32
    Rated operational current (A)380VAC-3912182532
    AC-43.557.78.512
    660VAC-36.68.9121821
    AC-41.523.84.47.5
    Rated conventional thermal current (A)2020324050
    Rated insulation voltage (V)690690690690690
    Rated operational
    power in category
    AC-3kw
    220V2.2345.57.5
    380V45.57.51115
    660V5.57.5101518.5
    Intermittent periodic duty-type
    motor frequency AC-4kw
    380V1.52.2345.5
    660V1.11.53.745.5
    Operation cycles
    (times/hour)
    ElectricalAC-31200120012001200600
    AC-4300300300300300
    Mechanical
    36003600360036003600
    Electrical life (X 10³times)AC-310010010010080
    AC-42020202020
    Mechanical life(X 10³times)
    1000100010001000800
    Matching fuse model
    RT16-20
    RT16-32RT16-40RT16-50
    Cold-pressed socketNon-prefabricate flexible cable Prefabricate flexible cable Non-prefabricate inflexible cablePieces1212121212
    mm²1/2.51/2.51/2.51/2.51.5/41.5/41.5/41.5/42.5/62.5/6
    1/41/2.51/41/2.51.5/61.5/41.5/101.5/62.5/102.5/6
    1/41/41/41/41.5/61.5/61.5/61.5/62.5/102.5/10
    Screw sizeM3.5M3.5M3.5M4M4M4M4
    Tightening torque(N·m)0.80.80.81.21.21.21.2
    Power of AC coil50HzClose(VA)707070110110
    Remain(VA)9.09.09.514.014.0
    Power(W)1.8-2.71.8-2.73-43-43-4
    Power of DC coil
    Power(W)99111111
    Operation rangeVoltage of closing: 85%Us-110%Us; V oltage of releasing: 20%Us-75%Us, DC:10%Us-75%Usl
    Specification of auxiliary contactsAC-15: 360VA DC-13: 33W Ith: 10A


    TypeCC1-D40CC1-D50CC1-D65CC1-D80CC1-D95
    Rated operational current (A)380VAC-34050658095
    AC-418.524283744
    660VAC-33439424949
    AC-49121417.321.3
    Rated conventional thermal current (A)6080809595
    Rated insulation voltage (V)690690690690690
    Rated operational
    power in category
    AC-3kw
    220V111518.52225
    380V18.522303745
    660V3037374545
    Intermittent periodic duty-type
    motor frequency AC-4kw
    380V7.5111518.522
    660V7.511111518.5
    Operation cycles
    (times/hour)
    ElectricalAC-3600600600600600
    AC-4300300300300300
    Mechanical
    36003600360036003600
    Electrical life (X 10³times)AC-38060606060
    AC-41515151010
    Mechanical life(X 10³times)
    800800800600600
    Matching fuse model
    RT16-63RT16-80RT16-80RT16-100RT16-125
    Cold-pressed socketNon-prefabricate flexible cable Prefabricate flexible cable Non-prefabricate inflexible cablePieces1212121212
    mm²6/254/106/254/106/254/1010/356/1610/356/16
    6/254/106/254/106/254/1010/356/1610/356/16
    6/254/106/254/106/254/1010/356/1610/356/16
    Screw sizeM4M8M8M8M8M8M8M10M10M10
    Tightening torque(N·m)1.23.53.53.53.53.53.54.04.04.0
    Power of AC coil50HzClose(VA)200200200200200
    Remain(VA)57.057.057.057.057.0
    Power(W)6-106-106-106-106-10
    Power of DC coil
    Power(W)2020202020
    Operation rangeVoltage of closing: 85%Us-110%Us; V oltage of releasing: 20%Us-75%Us, DC:10%Us-75%Usl
    Specification of auxiliary contactsAC-15: 360VA DC-13: 33W Ith: 10A



    2. Coil voltage of contactor and code of it(table 2) Table2


    Coil voltage Us(V)24364248110127220230240380400415440480600
    50HzB5C5D5E5F5G5M5P5U5Q5V5N5R5T5X5
    60HzB6C6D6E6F6G6M6P6U6Q5V665R6T6X6
    50/60HzB7C7D7E7F7G7M7P7U7Q7V7N7R7T7X7


  • Structure Characteristic

    1.CC1-D AC Contactor can combine with auxiliary contact blocks,delay timer ,thermal relay ect.to have more derivative products Table3

    Derived productsContactorAccessorial modularRelative products
    Time-delay contactor
    Delay timer
    Reversing contactor
    Mechanical interlock
    Electromagnetic starter
    Thermal
    Capacitor switching contactor
    Current-limited auxiliary block



    JR28N-25 Thermal Relay


    TypeRated frame current of thermal relayRated current(A)Current setting range(A)
    JR28N-25
    (LR2N-25)
    0.16, 0.25, 0.40, 0.63, 1.0, 1.6 2.0, 2.5, 4.0, 6.0, 8.0, 10.0 13.0, 18.0, 24.0, 32, 380.10-0.16, 0.16-0.25, 0.25-0.40 0.40-0.63, 0.63-1.0, 1.0-1.6 1.25-2.0, 1.6-2.5, 2.5-4.0, 4.0-6.0 5.5-8, 7-10, 9-13, 12-18, 16-24 23-32, 30-38



    TypeDelay scopeNumber of delay contactsPhoto
    LA2-DT0
    LA2-DT2
    LA2-DT4
    0.1s~3s
    0.1s~30s
    10s~180s
    NO+NC
    NO+NC
    NO+NC
    LA3-DR0
    LA3-DR2
    LA3-DR4
    0.1s~3s
    0.1s~30s
    10s~180s
    NO+NC
    NO+NC
    NO+NC

    Note: A,B,C,D is printed stands for the extend the length of time

    Table 5
    Auxiliary contact blocks TypeNumber of contactsPhoto
    Number of NONumber of NC
    LA1-DN2020
    LA1-DN1111
    LA1-DN0202
    LA1-DN4040
    LA1-DN3131
    LA1-DN2222
    LA1-DN1313
    LA1-DN0404



    2. Contactors can be mounted not only by screw but also 35mm & 75mm standard din rail.
    3.CC1-D-N is combined by 2 contactors and mechanical interlock, 2 contactors are mounted horizontally and interlock is mounted between 2 contactors, all components of interlock block are mounted in a moulded case.
    Note: Reversible products' specification above CC1-D4011A do not have connecting wire.

    General information
    1.Please provide us following information when you order:
    1.1Contactor's name, type
    1.2Coil voltage of contactor and frequency or code
    1.3If LA1 auxiliary contact blocks or standard din rail is needed, please inform us
    1.4Quantity of contactors
    1.5Standard derivative products N 3polos's connecting way is revisable, special connecting way must be mentioned.
    2.For example:CC1-D09 AC Contactor, coil voltage 220V 50HZ, 10 pieces. LA1-22 5 pieces.